2014+ Jeep Cherokee Forums banner

T'EYES CC3 2K Android Head Unit Review

75K views 316 replies 38 participants last post by  Gary Kline  
I’ve got the Sony 1080 camera ordered and on the way. Just like you said in your post I’m going to model and 3D print a mount. If it works solid enough I’ll share the .stl for all to use.
I’ve got the Sony 1080 camera ordered and on the way. Just like you said in your post I’m going to model and 3D print a mount. If it works solid enough I’ll share the .stl for all to use.
3D print would have been really nice.

By going through the hatch the Supplied RCA cable harness will come up 2- 2 1/2 ft short of head unit. Plan accordingly
 
So been reading this forum for a bit now. I bit the bullet and my new CC3 2K is coming in the mail now! I was reading about a summer project for the backup camera, I'm not sure how I'll feel about the factory one until I install my unit. Although I'm curious to know if someone has already swapped out the factory camera for an AHD one and if they used the factory wiring.
So been reading this forum for a bit now. I bit the bullet and my new CC3 2K is coming in the mail now! I was reading about a summer project for the backup camera, I'm not sure how I'll feel about the factory one until I install my unit. Although I'm curious to know if someone has already swapped out the factory camera for an AHD one and if they used the factory wiring.
yes see the article on here

Updated: Sony 1080P install and Loving it

HD camera, cannot use factory wiring. Must run your own. Well they give you the harness to run
As you can see in order for me to utilize the factory mount you need to get creative or just move it to the liscense plate frame off the hatch. Pulling wire from hatch to body is a pain, but doable.
The only issue I have is the back up lines over steer on screen and I have not found a setting to get them to act like the OEM lines .
But the pic is clear.
I did re wire the camera to trigger and power the camera off the same line. Otherwise the camera has power to it at all times the key is in on, I’m just trying to save some life in the camera. Unless you want to view while going fwd but that would just confuse me.
 
I ran into issues with mine a couple of times. 1st one was the canbus module coming loose, so I ran some loom tape from harness
and around the module to hold it securely .

Second one was the HVAC control plug was not snapped in fully, that will cause the odometer to blink as well.

Not had anymore of those issues since
Image
 
Hey @Lunatics,

Completely agree. In fact, any of us who have upgraded their head to the TEYES can probably attest to the exact same thing. I even wrote in the first post of this thread that the initial quality sounded like crap!!! I've never had an piece of audio equipment where the character of the sound can change so drastically by just EQ'ing it. It's like a Dr. Jekyll/Mr. Hyde kind of thing :ROFLMAO:

View attachment 235106
I must be tone deaf, I set it on Rock and have been happy
 
Two questions on the CC3 2K
1) is there a night mode on the screen so it’s not so bright and colorful during night driving?
2) when using Waze or google map and following directions does it send info to to the main dash screen like UConnect does ?

After 8 Years it’s time for a refresh
 
Here in NY, we barely had a winter. I would have used the heated wheel two or three times but use the radio/NAV every time I drive.

I'm actually liking this global warming thing. Makes me want to go discharge some aerosol cans in the air. 😂:oops:
Can you post a side view pic of the completed install? I’m two steps away from ordering just want a complete visual.