[ToyCop]

I just did the 2” spacers up front with new balljoints and Billstein shocks. I’ll be installing the stiletto rear control arm and Billsteins for the rear tomorrow.

 

[ToyCop]

Install went pretty well except I had to cut a rear endlink. Bought Moog endlinks for both sides. The 90 degree zerk fittings won’t work with the Gleaming Alloy Stilettos so I put in straight zerk fittings. Taking it for an alignment next week.

Also discovered the Discount Tire monkeys cross threaded one of my studs so I re-tapped the hole and used one of the studs I had as a spare after putting wheel locks on.

I’ll put the MFC metal collars on after the alignment.

 

[ToyCop]

Well, the plastic clips were super quick when everything was going back together. If they have to rotate the top mounts for the alignment wouldn’t the MFC clamps rotate?

 

[ToyCop]

I don’t quite believe if you can rotate them it’s bad. I have all new suspension at this point and I can spin them around. New top mounts, new shocks and they can spin. They will be replaced though.